Hardware, made clear.

Learn the difference between center-to-center spacing, overall length and projection; compare current OBJECT & TONE sizes; and use separate planning paths for replacement hardware and undrilled cabinetry.

This is the first guide to use when existing holes, drawer width, door proportions or appliance clearances will determine the choice.

Compare Natural Brass, Antique Brass, Matte Black, Brushed Nickel and the selected CHROMA colors by undertone, contrast and surrounding materials. The guide also explains why a physical sample is the most reliable final check.

Concise answers cover material, sizing, finish, installation, care, warranty and ordering questions. Use the question hub when you need a direct answer to a specific hardware decision.

Knobs and T-bars create compact points of contact. Standard pulls offer a longer grip for frequently used drawers and doors. Long pulls establish a stronger vertical or horizontal line on tall cabinetry and wide fronts.

Choose the format for function first, then keep the room coherent by repeating a collection, finish or design detail.

Remove one two-hole pull and measure from the center of one mounting hole to the center of the other. Match that center-to-center measurement whenever possible, then confirm the new overall length and base dimensions cover any marks from the previous hardware.

Do not order a replacement pull from overall length alone.

On undrilled fronts, compare more than one size with a paper template or low-tack tape. View the full elevation, operate adjacent doors and drawers, and check clearances around trim, countertops and appliances.

The installer responsible for the cabinetry should confirm the final drilling position.

Judge hardware beside cabinet paint or timber, stone, tile, plumbing and lighting in the room's real daylight and artificial light. A finish can coordinate through shared warmth, deliberate contrast or repeated texture without matching every nearby metal exactly.

Photography and display settings cannot reproduce every undertone, texture or reflection. For larger projects, compare an eligible physical sample against the actual cabinetry and neighboring materials before placing the full order.

Review the Samples page for current eligibility and any applicable Design Sample Credit terms.

Confirm the product schedule, panel thickness and clearance before drilling. Mark every front from one reference system, test the setup on comparable material where possible, drill square and tighten only until each base is securely seated.

Standard 25 mm mounting screws are included for typical single-panel cabinet doors and drawer fronts. Applied panels, double fronts and unusually thick or thin construction may require a different length and installer judgment.

Measure at the mounting point; do not compensate for an unsuitable screw by over-tightening.

Use a clean, soft cloth for regular care. When needed, apply warm water with a small amount of mild soap to the cloth, remove residue with a second damp cloth and dry thoroughly.

Avoid abrasive pads, metal polish, bleach, acids, ammonia, solvents and strong household sprays unless product-specific instructions expressly approve them.

Eligible OBJECT & TONE cabinet hardware is supported by a 10-year limited mechanical warranty for manufacturing and mechanical defects under normal indoor residential use.

The warranty does not promise that a finish will remain visually unchanged for ten years. Review the complete policy for coverage, exclusions and the claim process.

For selection help, share the product or collection, desired finish, quantities, cabinet dimensions, panel thickness and any existing hole spacing. Front-on cabinet photographs plus one image of the surrounding room help explain scale and adjacent materials.

Qualified design and building professionals can inquire about finish coordination, hardware schedules, quantities and project support through the Trade Program. Include business information, project type, approximate quantities and timing.

For an order, installation or product concern, send the order number when available, product name, finish, size, panel thickness, a description of the issue and clear photographs of the full installation and affected detail.

Do not force, re-drill, polish or discard the hardware while the condition is being reviewed.